Standard Features
- Lifting lugs
- Arrester mounting pads
- High-voltage porcelain bushing(s) with eyebolt termina
- Low voltage bushing insulators are available in fiberglass reinforced polyester material or porcelain (both eyebolt and spade terminals)
- Low-voltage neutral grounding strap (furnished on 10 - 50 kVA single HV bushing units)
- ANSI support lugs (hanger brackets)
- Cover has 15 kV dielectric insulation and increased resistance to corrosion. The cover is sloped 15°, preventing water from collecting and thereby reducing the chances of corrosion and leaking.
- Self-venting and resealing cover that eliminates the need for an auxiliary pressure-relief device and offers increased safety through higher tank withstand
- Wound core with step-lap joints for increased efficiency and lower noise levels.
- Core/coil bolts in pads are 180° apart
- Embossed low-voltage leads
- Oil fill-plug
- Cover ground-strap
- Tank ground-pad
- Laser-etched, anodized, aluminum nameplate with bar-coded serial number
- Durable, corrosive-resistant paint finish
The following additional features are all standard on self-protected type CSP units (CSP protection package consists of four components that work together to provide complete, self-contained protection against surge currents, short circuits, and overloads):
- Primary protective link
- Surge arrester
- Secondary circuit breaker
- Secondary breaker operating handle with emergency overload reset
- Overload signal light if desired
